If your device becomes unpaired or you receive a replacement LIGHTSPEED wireless adapter, do the following to pair your device:

1. Plug in the LIGHTSPEED wireless adapter.
2. Insert a pin into the reset port on the LIGHTSPEED wireless adapter to initiate pairing mode. The light on the adapter will blink.
3. Turn on the headset.
4. Remove the left ear pad on the headset.
5. Insert pin into pin-hole located below the speaker driver and between the lower two screws. The headset will blink and chime.
   
6. Wait 10-15 seconds for pairing to complete — blinking stops on both the headset and adapter and you'll hear a chime in the headset to indicate pairing is complete.