Sustainability Navigation

Support

Welcome to Logitech Support

We regret that we cannot process payments at this time. We are working on the issue. Please check back or contact your preferred local retailer.

Pair Jaybird RUN / RUN XT earbuds

There are no Downloads for this Product

There are no FAQs for this Product

There are no Documents available for this Product. If you have questions, browse the topics on the left.

There are no Spare Parts available for this Product

There are no videos available for this product

There are no FAQs for this Software.

There are no Documents available for this Software. If you have questions, browse the topics on the left.

There are no Videos available for this Software.

Right out of the box, your Jaybird RUN earbuds come ready to pair. Here's how:
  1. Remove your earbuds from the charging case and put them in your ears. 
  2. On your Bluetooth device, go to Bluetooth settings, make sure Bluetooth is on, and select Jaybird RUN on the available devices list. 
  3. Once connected, you will hear “Connected” on your right earbud. The right earbud is the master and will connect to the left earbud automatically.

    Pair RUN Earbuds

To pair an additional Bluetooth device, or manually initiate pairing mode, follow the relevant steps below. 

Start with earbuds in charging case:
  1. Start with both earbuds in the charging case with the lid closed.
  2. Open the charging case and remove your right earbud from the charging case.
  3. Close the charging case and turn off your right earbud by pressing the multifunction button for three seconds.
  4. Press and hold the right multifunction button for six seconds until you see the LED flashing green. When the LED flashes green, the earbud is in pairing mode. 
  5. A voice prompt will say “Go to Bluetooth settings and select Jaybird RUN”.
  6. Go to your Bluetooth settings on your device and select “Jaybird RUN” in the list of discovered devices to connect. 
  7. Once connected, you will hear “Connected” from your right earbud. The right earbud is the master and will peer connect to the left earbud automatically.
Start with earbuds out of charging case:
  1. Make sure your earbuds are off.
  2. Press and hold the right multifunction button for six seconds until you see the LED flashing green. When the LED flashes green, the earbud is in pairing mode. 
  3. A voice prompt will say “Go to Bluetooth settings and select Jaybird RUN”.
  4. Go to your Bluetooth settings on your device and select “Jaybird RUN” in the list of discovered devices to connect. 
  5. Once connected, you’ll hear “Connected” from your right earbud. 
  6. Ensure your left earbud is turned on by pressing the multifunction button for three seconds. The right earbud is the master and will connect to the left earbud automatically.
Your Jaybird RUN earbuds can remember the pairing information for up to four devices. 

If you’re having trouble pairing your earbuds, try the following steps:
  1. Turn off Bluetooth on your audio device for at least 10 seconds and then back on, then try to pair.
  2. Turn your audio device off and back on, then try to pair.
  3. Go to your devices Bluetooth settings and forget Jaybird RUN if present. Then try to pair.
  4. If you still have no luck, try resetting your earbuds. See Reset the Jaybird RUN earbuds for help.
 


 

Frequently Asked Questions

    • There are no products available for this section

    There are no Downloads for this Product

    There are no Downloads for this Version.

    Show All Downloads

    Product Specific Phone Numbers

    Main Phone Numbers

    Was this article helpful?
    0 out of 0 found this helpful
    Return to top