Your Alert security camera has a status LED to let you know what is going on with it.
Indoor Alert Camera
Outdoor Alert Camera
| LED while powering on | ||
 |
Green | POST successful (very brief) |
 |
White | POST running, OS is booting |
 |
Light Blue | System is booting up (may take up to 90 seconds) |
 |
Red | Camera boot-up failed. If you cannot get it to go past this by doing a hard reset several times, then the camera may need to be replaced. |
| LED after powering on | ||
|
Green | Connected to internet |
 |
Purple | Connected to Alert Commander |
 |
Blue | Connected to Alert Commander and internet |
|
White | Upgrading firmware |
 |
Yellow | Camera in standalone mode |
|
Light Blue | Not connected to Alert Commander or internet |
 |
White / Yellow Blinking | Camera is resetting after manual reset |
 |
Red Blinking | Camera boot-up failed |
 |
Red / Yellow Blinking | MicroSD card read/write failure - No microSD card |
Troubleshooting tips:
Green LED – The camera is connected to the internet, but not to Alert Commander:
- Use the camera’s pin hole to reset it and let it perform a power cycle.
- Close the Alert Commander software and then restart it.
White LED – In most cases, this indicates that the camera is performing a power cycle. However, if the LED stays white, please do the following:
- Use the camera’s pin hole to reset it and let it perform a power cycle.
- Close the Alert Commander software and then restart it.
Red LED – This indicates that camera boot-up has failed. Please do the following:
- Use the camera’s pin hole to reset it and let it perform a power cycle. If the LED stays red after the power cycle, the camera may need to be replaced.
- Close the Logitech Alert Commander software.
- Use the camera’s pin hole to reset it and let it perform a power cycle.
- Remove any passwords previously assigned in Alert Commander.
- Connect the camera to a power outlet where an existing camera is working properly. If the camera works on this outlet, there is a problem with the electrical line where the camera was previously connected.
Purple LED – This means camera is connected to the Alert Commander software but not the internet. Do the following to resolve the problem:
- Close and restart the Alert Commander software.
Important Notice: The Firmware Update Tool is no longer supported or maintained by Logitech. We highly recommend using Logi Options+ for your supported Logitech devices. We are here to assist you during this transition.
Important Notice: The Logitech Preference Manager is no longer supported or maintained by Logitech. We highly recommend using Logi Options+ for your supported Logitech devices. We are here to assist you during this transition.
Important Notice: The Logitech Control Center is no longer supported or maintained by Logitech. We highly recommend using Logi Options+ for your supported Logitech devices. We are here to assist you during this transition.
Important Notice: The Logitech Connection Utility is no longer supported or maintained by Logitech. We highly recommend using Logi Options+ for your supported Logitech devices. We are here to assist you during this transition.
Important Notice: The Unifying Software is no longer supported or maintained by Logitech. We highly recommend using Logi Options+ for your supported Logitech devices. We are here to assist you during this transition.
Important Notice: The SetPoint software is no longer supported or maintained by Logitech. We highly recommend using Logi Options+ for your supported Logitech devices. We are here to assist you during this transition.
Frequently Asked Questions
There are no products available for this section
There are no Downloads for this Product
There are no Downloads for this Version.
Compatible Product
