The Driving Force Shifter is equipped with a built-in clamping system that can be mounted to a table or desk, or mounted to a racing rig using the built-in bolt mounting points.
NOTE: Before you mount and secure the Driving Force Shifter, connect it to the G29 or G920 wheel unit using the connection port (DB-9 male) on the underside of the wheel unit.

Clamping system
To mount the Driving Force Shifter using the clamping system:

1. Push down and then rotate the clamp knobs to lock or unlock.
2. Rotate the clamp knobs to tighten or loosen the clamps.
3. Rotate the underside bolt to securely fasten the shifter to the table or desk.

   

Bolt mounting points
You’ll need two (2) M6X1 screws to securely fasten the shifter to the racing rig. For a mounting template, see:

• Shifter Bolt Template

NOTE: Bolt mounting may also be supplemented with the built-in clamping system (where applicable)