Install your iPad into the Rugged Combo/Case. |
|
Turn on the iPad. |
|
Make sure your iPad and Rugged Combo/Case are updated to the correct iOS and firmware. See Important update information. |
|
Review the student user tips. See Rugged Combo Student User Tips. |
Product Overview
1 | Headphone jack |
2 | Power on/off button |
3 | Volume + / - buttons |
4 | Secure connector |
5 | Speaker holes |
6 | Lightning Connector pass-through |
Learn more about your Rugged Combo
Ensure you have iOS 10.3.3 or later installed on your iPad
To check and update the version of iOS:
- On your iPad, tap Settings, then General.
- Under General, go to the About section. If it’s earlier than 10.3.3, you will need to update. Continue to the next step.
- Tap Software Update, and then follow the on-screen instructions to download and install.
To check the Rugged Case firmware version:
- Make sure your iPad is connected to the Rugged Case.
- On your iPad, tap Settings and then tap General.
- Under General, go to the About section.
NOTE: Your Rugged Case is connected if it appears in the device list. - Select the Rugged Case to check the Firmware version. If it is earlier than 0.3.8, tap Update, and then follow the instructions to install.
Frequently Asked Questions
There are no products available for this section
There are no Downloads for this Product
There are no Downloads for this Version.
Show All Downloads