Sustainability Navigation

Support

Welcome to Logitech Support

Cannot assign the Pro Flight Cessna Trim wheel to the elevator trim control axis in FSX

There are no Downloads for this Product

There are no FAQs for this Product

There are no Documents available for this Product. If you have questions, browse the topics on the left.

There are no Spare Parts available for this Product

There are no videos available for this product

There are no FAQs for this Software.

There are no Documents available for this Software. If you have questions, browse the topics on the left.

There are no Videos available for this Software.

To assign the Pro Flight Cessna Trim wheel to the elevator trim control axis in FSX, do the following:
  1. Connect the Pro Flight Cessna Trim wheel and launch FSX.
  2. Go to Settings > Controls > Control Axis
  3. Select "Cessna Trim Wheel" in the Controller type drop down menu.
  4. Scroll down to Elevator Trim Axis and click Change Assignment.
  5. Rotate the trim wheel 3-5 times in the same direction until the word "Trim" appears in the assignment box, then click OK. 
NOTE: Depending on how your previous axis assignments were configured, you may need to make additional changes, like making sure that there is not a key assigned or a joystick function assigned to the same axis. Delete any conflicts as needed.

Frequently Asked Questions

    • There are no products available for this section

    There are no Downloads for this Product

    There are no Downloads for this Version

    Show All Downloads

    Product Specific Phone Numbers

    Main Phone Numbers

    Was this article helpful?
    0 out of 0 found this helpful
    Return to top