You can customize the onboard profile settings using the Logitech G HUB.
These settings include button programming, report rate, performance/endurance modes and tracking behavior.
G502 LIGHTSPEED allows up to 5 DPI settings By default, G502 LIGHTSPEED has the following settings:
– DPI: 400/800/1600/3200/6400
– Report rate: 1ms
Tips:
– G502 LIGHTSPEED has 1 on‑board profile by default but supports up to 5 onboard profiles
– Extra profiles can be added using Logitech G HUB.
– DPI/Onboard profiles are shown using three LEDs above the thumb buttons.
– The illustrations below shows which values are being indicated by the LED panel.
Important Notice: The Firmware Update Tool is no longer supported or maintained by Logitech. We highly recommend using Logi Options+ for your supported Logitech devices. We are here to assist you during this transition.
Important Notice: The Logitech Preference Manager is no longer supported or maintained by Logitech. We highly recommend using Logi Options+ for your supported Logitech devices. We are here to assist you during this transition.
Important Notice: The Logitech Control Center is no longer supported or maintained by Logitech. We highly recommend using Logi Options+ for your supported Logitech devices. We are here to assist you during this transition.
Important Notice: The Logitech Connection Utility is no longer supported or maintained by Logitech. We highly recommend using Logi Options+ for your supported Logitech devices. We are here to assist you during this transition.
Important Notice: The Unifying Software is no longer supported or maintained by Logitech. We highly recommend using Logi Options+ for your supported Logitech devices. We are here to assist you during this transition.
Important Notice: The SetPoint software is no longer supported or maintained by Logitech. We highly recommend using Logi Options+ for your supported Logitech devices. We are here to assist you during this transition.
Frequently Asked Questions
There are no products available for this section