If your device becomes unpaired or you receive a replacement LIGHTSPEED wireless adapter, do the following to pair your device:
- Plug in the LIGHTSPEED wireless adapter.
- Insert a pin into the reset port on the LIGHTSPEED wireless adapter to initiate pairing mode. The light on the adapter will blink.
- Turn on the headset.
- Remove left ear pad on headset
- Insert pin into pin-hole located below the speaker driver labeled Pairing.
- Wait 10-15 seconds for pairing to complete — blinking stops on both headset and adapter and you will hear a chime in the headset to indicate pairing is complete.
Important Notice: The Firmware Update Tool is no longer supported or maintained by Logitech. We highly recommend using Logi Options+ for your supported Logitech devices. We are here to assist you during this transition.
Important Notice: The Logitech Preference Manager is no longer supported or maintained by Logitech. We highly recommend using Logi Options+ for your supported Logitech devices. We are here to assist you during this transition.
Important Notice: The Logitech Control Center is no longer supported or maintained by Logitech. We highly recommend using Logi Options+ for your supported Logitech devices. We are here to assist you during this transition.
Important Notice: The Logitech Connection Utility is no longer supported or maintained by Logitech. We highly recommend using Logi Options+ for your supported Logitech devices. We are here to assist you during this transition.
Important Notice: The Unifying Software is no longer supported or maintained by Logitech. We highly recommend using Logi Options+ for your supported Logitech devices. We are here to assist you during this transition.
Important Notice: The SetPoint software is no longer supported or maintained by Logitech. We highly recommend using Logi Options+ for your supported Logitech devices. We are here to assist you during this transition.
Frequently Asked Questions
There are no products available for this section