The following steps detail how to setup your Logitech ClearChat PC Wireless out of the box.

1. Fully charge the headset using the included AC charger. (See "Power and Charging" section.)

2. With your computer turned on, plug the wireless adapter into the wireless adapter stand (preferred) or directly into an open USB port on the computer. The status light on the wireless adapter will blink green. If it is your first time connecting the wireless adapter to your computer, you may notice a pop-up notification or sound that indicates the computer has properly detected the wireless adapter.

3. Use the power switch to turn on the headset. The status light will blink green until a wireless connection has been established with the wireless adapter. The status light on both the headset and wireless adapter will turn solid green once a wireless connection is established.

   

   NOTE: Your Logitech audio device does not require installation of additional drivers or software. They use drivers that are already built into your operating system.

Additionally, you can configure your Logitech audio device using your operating system's audio settings. Please refer to Knowledge Base article 360023400653.