1. Plug your G700 directly into your computer with the USB cable.

2. When all 3 LED indicator lights are solid green, the mouse is at full charge.

NOTE: Do not use the included USB extension cable with your G700's USB cable. The G700 mouse should plug directly into a available USB port on your computer to minimize the amount of time required to charge.

1. The connect utility is installed with the SetPoint. If you don't have SetPoint installed, you can download it from the G700 Downloads Page.

2. Make sure that the receiver is plugged into a working USB port on your computer.

3. Disconnect other Logitech wireless receivers before proceeding.

4. Open up the "connect.exe" application installed with SetPoint. This is located at C:\Program Files\Logitech\SetPointP\connect.exe

   NOTE: If you have the G700 plugged directly into your computer via the USB cable, you must remove the cable now to properly complete the connection procedure.

5. Follow the onscreen instructions:

   

6. If the mouse is successfully detected, the following screen will appear. Click "Done" to finish the procedure

   

7. If the screen does not change, retry the steps shown in Step #5 again, but let the mouse stay at "Off" for at least 5 seconds.

If the mouse does not function after following those steps, please see Knowledge Base article 18026.