Your X3 buds come out of the box ready to pair and can remember the pairing information for up to 8 devices.
If you’re trying to pair an additional audio source device, you’ll need to manually initiate pairing mode on your buds:
- With your buds turned off, press and hold the Power Button until you see the LED flashing red/green. When the LED flashes red/green, the buds are ready to pair.
- A voice prompt will say “Searching for your music device”.
- Select “Jaybird X3” in the list of discovered devices to connect. Once connected, you will hear “Headphones connected” from your buds.
Important Notice: The Firmware Update Tool is no longer supported or maintained by Logitech. We highly recommend using Logi Options+ for your supported Logitech devices. We are here to assist you during this transition.
Important Notice: The Logitech Preference Manager is no longer supported or maintained by Logitech. We highly recommend using Logi Options+ for your supported Logitech devices. We are here to assist you during this transition.
Important Notice: The Logitech Control Center is no longer supported or maintained by Logitech. We highly recommend using Logi Options+ for your supported Logitech devices. We are here to assist you during this transition.
Important Notice: The Logitech Connection Utility is no longer supported or maintained by Logitech. We highly recommend using Logi Options+ for your supported Logitech devices. We are here to assist you during this transition.
Important Notice: The Unifying Software is no longer supported or maintained by Logitech. We highly recommend using Logi Options+ for your supported Logitech devices. We are here to assist you during this transition.
Important Notice: The SetPoint software is no longer supported or maintained by Logitech. We highly recommend using Logi Options+ for your supported Logitech devices. We are here to assist you during this transition.
Frequently Asked Questions
There are no products available for this section