By default, the G935 gaming headset enters sleep mode after fifteen minutes of inactivity (no audio input or output).
Sleep mode conserves power on the G935 gaming headset, and prolongs usage before you need  to recharge the headset’s battery.
You can extend the timer start time up to 60 minutes, or disable it entirely. 

To configure the G935 sleep timer:
1. Make sure that G HUB is installed on your computer. You can get the update from the product’s Download page.
2. Connect the G935 wireless receiver to a USB port on your computer.
3. Set the switch on your G935 gaming headset to Wireless On mode.
4. Launch G HUB, select the G935 and click the G935 Settings icon at the top right.



5. Under the Sleep Timer section choose your desired time before the G935 enters sleep mode:



Note: When in sleep mode the main lighting on the headset will turn off and the G logo will enter breath mode (slowly pulse on and off).

Power Off mode
Once your G935 headset has entered sleep mode it can be woken up by either pressing a button on the headset or if it detects an audio signal from your PC or console.  
After 30 minutes of sleep mode being enabled the G935 will enter Power Off mode to further ensure no battery wastage.  
When in Power Off mode all lighting will extinguish.

Once in Power Off mode, the only way that you can turn the headset back on again is by sliding the power button off and then on again.


Pair the G935 gaming headset to the USB Wireless Adapter
If your device becomes unpaired or you receive a replacement USB Wireless Adapter, follow these instructions to pair your device with the USB Wireless Adapter:
1. Plug in USB Wireless Adapter
2. Insert pin into reset port on adapter to initiate pairing mode
3. Light on adapter will blink
4. Turn on headset
5. Hold “Microphone mute” button for 15 seconds to initiate pairing mode
6. Headset G logo will blink green to indicate pairing mode
7. Logo will turn to solid color and then return to currently selected lighting when paired