To reset your headphones:
Bluebuds X and X2
If the headphones are already turned on in Standby mode, or connected to an audio device, you can get the headphones into pairing mode by pressing and holding both volume buttons until you see the light on the headphones begin to flash red and green, indicating pairing mode. Follow the steps above at this point to reset your BlueBuds X or X2 headphones.
Bluebuds X and X2
1) Turn headphones off
2) Put headphones in pairing mode (hold middle button for 6-8 seconds until it says, "Searching for your Music Device")
3) LED will flash red and green
4) Hold both volume buttons down 6-8 seconds, this will reset the headphones
5) LED will flash orange 3 times
6) Delete Bluetooth profile from the device
7) Put headphones back into pairing mode and connect them to your device.
If the headphones are already turned on in Standby mode, or connected to an audio device, you can get the headphones into pairing mode by pressing and holding both volume buttons until you see the light on the headphones begin to flash red and green, indicating pairing mode. Follow the steps above at this point to reset your BlueBuds X or X2 headphones.
Frequently Asked Questions
There are no products available for this section
There are no Downloads for this Product
There are no Downloads for this Version
Show All Downloads
Compatible Product
