You can teach commands from your original remote to the Harmony remote while you are adding a device, while fixing device settings, when adding a missing command, or when fixing a button or screen option.

To teach commands

When you set up your Harmony remote, you may have to teach commands from your original remote to the Harmony remote.

1. If you do not have your Harmony remote connected to your computer, you are prompted to connect it using the USB cable.
2. Refer to the online instructions for details about positioning your Harmony remote and original remote.
3. Follow the online instructions, pressing the corresponding command button on your original remote. If the Harmony remote recognizes the command, you will see “Command Received” message on the remote screen as the new command is taught to the Harmony remote.
   
   NOTE: If you have problems teaching, see Knowledge Base article 18088.
   
   Continue teaching buttons as indicated on the screen. Once all commands have been successfully recognized, the Finish button will appear.
   
   
4. Click Finish.
5. When you are finished, click Sync, Sync Now to update your Harmony remote with your new settings.
   
   NOTE: If you do not have your Harmony remote connected to your computer, you are prompted to connect it using the USB cable.
   
   
6. A page appears showing the progress as your Harmony remote is updated with your device information.

The sync process could take a few minutes as your Harmony remote is updated with your account information. During the update, do not unplug your Harmony remote unless prompted to do so.