Sustainability Navigation

Support

Welcome to Logitech Support

Change the X55 Rhino / X56 H.O.T.A.S. F.E.E.L. Spring

There are no Downloads for this Product

There are no FAQs for this Product

There are no Documents available for this Product. If you have questions, browse the topics on the left.

There are no Spare Parts available for this Product

There are no videos available for this product

There are no FAQs for this Software.

There are no Documents available for this Software. If you have questions, browse the topics on the left.

There are no Videos available for this Software.

To insert, change or remove a spring, follow these steps.

NOTE: Make sure the trigger is facing away from you and that the logo plate on the device is facing you.
  1. Turn the Locking Bezel (part B) counterclockwise until the Stick comes away from the base.
  2. Remove the Seal Ring (part C) by placing finger from your left and right hand under the ring on either side, and then lift up. The Seal Ring it stiff by design
  3. Pry apart the Locking Clamps (part D). These pull apart from the stick, but are under load from the spring. Take one half off first, hold the spring, and then remove the other half.
  4. Remove the Spring (part E), then either replace with a new Spring or leave the Spring off.
To reassemble, reverse the order of the above steps, making sure to securely seat the Seal Ring (Part C) and firmly tighten the Locking Bezel (part D) on the Stick base.

FEEL Spring Assembly


 

Frequently Asked Questions

    • There are no products available for this section

    There are no Downloads for this Product

    There are no Downloads for this Version

    Show All Downloads

    Product Specific Phone Numbers

    Main Phone Numbers

    Was this article helpful?
    0 out of 0 found this helpful
    Return to top