If you've replaced a Rally Display Hub, remote, or camera, use the following steps to perform three-way pairing between the remote control, the camera, and the Display Hub.

NOTE: If these devices are not properly paired, firmware updates will fail.

1. Press and hold the button on the camera until the LED flashes.
2. Press and hold the button on the Display Hub until the LED flashes.
3. Press and hold the Bluetooth button on the remote control until the LEDs on both the camera and Display Hub stop flashing. The devices should now be paired.
4. If the pairing fails, repeat from step 1.
5. After pairing is successful, check system firmware is up to date.