If the LED on the control dial is slowly blinking, it may be because it’s lost the connection to the speakers. The dial will slowly blink for 30 seconds if it’s unable to reconnect. This may be caused by:
- The control dial is too far away from the speakers — try to get closer. The control dial will stop blinking once it reconnects.
- Your Z407 speaker is not turned on, and therefore the dial could not reconnect to the speakers. Turn on your Z407 speaker, and make sure that your dial is within range to reconnect.
For more LED status information, please see the Z407 Quick Setup Guide.
Important Notice: The Firmware Update Tool is no longer supported or maintained by Logitech. We highly recommend using Logi Options+ for your supported Logitech devices. We are here to assist you during this transition.
Important Notice: The Logitech Preference Manager is no longer supported or maintained by Logitech. We highly recommend using Logi Options+ for your supported Logitech devices. We are here to assist you during this transition.
Important Notice: The Logitech Control Center is no longer supported or maintained by Logitech. We highly recommend using Logi Options+ for your supported Logitech devices. We are here to assist you during this transition.
Important Notice: The Logitech Connection Utility is no longer supported or maintained by Logitech. We highly recommend using Logi Options+ for your supported Logitech devices. We are here to assist you during this transition.
Important Notice: The Unifying Software is no longer supported or maintained by Logitech. We highly recommend using Logi Options+ for your supported Logitech devices. We are here to assist you during this transition.
Important Notice: The SetPoint software is no longer supported or maintained by Logitech. We highly recommend using Logi Options+ for your supported Logitech devices. We are here to assist you during this transition.
Frequently Asked Questions
There are no products available for this section