The PRO Racing Wheels come equipped with bolt mounting points on the bottom of the wheelbase and pedals units.This lets you attach them to a surface with M6X1 screws.

You can download these templates to get started with DIY wheel installation:

• Pedal Base template

• Pedal Module template

• Wheel Base template

Clamping System (Easy)

Tools required: None

1a. Place the wheelbase on your desk and ensure the feet at the bottom are aligned against the edge.

1b. Insert the clamp into the hole at the front.

1c. Tighten the clamp by adjusting the screw handle. Once the clamp has come into contact with the desk, you only need between a half and one full turn of the handle to achieve the correct level of clamping. Do not overtighten.

NOTE:

–Also be aware of the construction of your desk and its suitability for clamping a high-torque wheel to it. Some desks use a hollow-core construction, for example, where you have a top piece of material and a bottom piece. Those pieces are likely to be thin and are unlikely to stand up to the forces applied when the wheel is clamped in place. Logitech recommends only clamping your PRO Wheel to a desk made from a solid material, such as MDF or wood.

Try to shake your desk gently, if it shakes easily; that might not be an ideal desk for your new wheel. (Avoid desk with caster wheels)

Mounting on racing seat (Easy)

Tools required: M6 Bolts, Washers, Spanner or HEX allen key.

Using this method you need an additional racing seat with a mounting frame.

2a. Use the three bolt holes on the underside of the PRO Racing wheel to attach it to most major racing seats.

• You will need 3 x M6 bolts (not included in the package) with a maximum depth inside the wheelbase of 15mm. Remember to account for the thickness of the surface that you are attaching the wheelbase to.

•  Using a longer bolt than this will damage the wheel unit, so use washers if needed to ensure that the bolts do not encroach too far inside the wheel base.
•  You only need to hand tighten using a spanner or hex allen key; depending on the type screws you buy. Do not use power tools to tighten the bolts.

2b. You can use the included cover to fill the clamp hole when attaching to a racing seat.

Do not use the wheel rim as leverage to assist you when getting into or out of your racing seat as this will damage your PRO Racing Wheel.

Mounting using template (DIY)

Tools required: Drilling machine,M6 Screws (Size depends on the thickness of the top plate of your table), Washers, Spanner or HEX allen key.

Note: Be careful with the power tools; if you are unsure what you are doing please take local expert advice.

You need to download the template and print with its original size to avoid any complication or misalignment while installing wheelbase.