If you’re not hearing audio from your left Jaybird RUN bud, it may need to be re-connected to the right master bud.

To connect your left RUN bud:

1. Open the Bluetooth settings on your device and forget Jaybird RUN from the list of paired devices.
2. Take both buds out of the charge case and turn them off manually by pressing the multi-function button for three seconds. A red LED will confirm the buds turning off.
3. Grab your right bud and press the multi-function button for six seconds until the green LED starts to blink.
4. Double-press the multi-function button. The bud will reset (orange LED) and turn off (red LED).
5. Press the multi-function button for six seconds until the green LED starts to blink.
6. Single-press the multi-function button (within 10 seconds), the green LED will blink faster.
7. Now grab your left bud and press the multi-function button for six seconds until the green LED blinks at the same speed as the right bud.
8. Place both buds close together until the left LED turns off confirming that the left and right are connected.
   You can now pair Jaybird RUN to your device again.

Pairing RUN to your device:

1. Turn off the right bud by pressing the multi-function button for three seconds.
2. Enter pairing mode by pressing the multi-function button for six seconds.
3. Go to Bluetooth settings on your device and select Jaybird Run.